Laminating Adhesives

The fast cure laminating adhesives which we offer are made of solvent free materials. These are designed in unfilled, single component, moisture-curing material with fast cure composition based on polyether polyols. We offer these adhesives at cost competitive price.

Laminating Adhesive

REQUEST CALLBACK

Ask for Price

Product Price: Ask Latest Price

Product Details:

Specific Gravity1.1
Flash PointLess than 200 degree C
Storage Stability9 months (temperate)
Viscosity3-4,000 mPas at 25 degree C
NCO Value12 %
AppearanceClear Brown Liquid
Surface of ApplicationPlastic, Paper
Grade StandardIndustrial Grade

We are engaged in manufacturing wide range of Fast Cure Laminating Adhesives which are solvent-free materials. These are designed in unfilled, single component, moisture-curing material with fast cure composition based on polyether polyols.

 

Application:

  • The usage rate of the material will be very dependent on the nature and porosity of the surfaces to be bonded. Good bonds can be achieved at a thickness between 50 and 100 micron.
  • When used on non-porous substrates coverage will be 10-20 m²/kg.
  • Use of a roller is the preferred method of application for maximum coverage.
  • Materials to be bonded should be grease, dust and dirt free. Test bonding should always be carried out. This is particularly important with non-porous substrates.
  • Sufficient even pressure should be applied to the bonded materials during the curing stage to ensure good adhesion. A period of between 1 and 4 hours will be required dependent on the temperature and the nature of the materials to be bonded.
  • FP 1150 should not be applied to wet surfaces (i.e. surfaces where there are visible signs of moisture such as obviously damp patches) but it is not necessary to dry materials that have been stored in good conditions, indoors.
  • FP 1150 does not normally require water misting unless two non porous surfaces are to be bonded although water misting is not detrimental to the product and may result in a faster full cure.

Uses: 

  • FP 1150 is specially formulated to give a relatively low viscosity and a fast cure.
  • FP 1150 is used as a laminating adhesive and is particularly suitable for the bonding of paper based materials and can be used on other surfaces such as chipboard, galvanized steel, GRP and other plastics, glass, wood, cork, polyurethane foam, polystyrene and mineral wool.
  • FP 1150 is designed to be hand applied by roller, squeegee, scraper etc., but can be applied by mechanical means.

Storage:

  • Store in a cool, dry place, indoors and avoid unnecessary opening of containers. Do not add any other materials to this product without written permission from the manufacturer.
  • Once opened FP 1150 will start to cure and a skin will form. Partly used containers should be resealed immediately and re-used as quickly as possible.

 

Used Containers:

 

Rinse thoroughly with a strong aqueous detergent solution and LEAVE PERMANENTLY OPEN. The reaction of isocyanates with water leads to the formation of carbon dioxide, which can result in pressure build-up in closed containers.

 

Healthy & Safety 

The recommendations made in the material safety data sheet (MSDS) for this product should be followed at all times.


    Yes! I am Interested

    Liquified Laminating Adhesive

    REQUEST CALLBACK

    Ask for Price

    Product Price: Ask Latest Price

    Product Details:

    Flash PointLess than 200 degree C
    Storage Stability9 months (temperate)
    AppearanceClear Brown Liquid
    Surface of ApplicationPlastic
    FeaturesMoisture Resistant, Impact Resistant
    Grade StandardIndustrial Grade

    We are the leading manufacturer and supplier of Liquified Laminating Adhesive.

    Yes! I am Interested

    X
     





    Explore More Products